![]() ![]() You might decide to change the anyconnect login prompt to state that the second authentication of a 2FA security code is required. So pretty much the first factor is the RADIUS authentication.īecause 2FA, uses two authentication sources, as the name suggest, you will also need to add a secondary authentication method, this time I have used a server group called VIP (using Symantec's VIP service). I will address the ISE configuration part of this in a separate post. shows that the authentication is set to AAA, which is offloaded to ISE using RADIUS, which authenticates, on (very likely) AD credentials. Now drill into the connection profile itself. choose to "Bypass interface access lists for inbound VPN sessions.enable Cisco Anyconnect acces on the outside interface.1 the first step in the authentication process is to connect to ISE which then connects to AD, you could configure it to go to AD directly. the diagram below show a diagram of the steps the FW goes through when using 2FA authentication:Īs you can see in Fig. I will use screenshots of ASDM, and at the end I will add the required CLI commands.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |